Drawing And Wiring The Building Electricity E-Learning

Virtual training of building electrical drawing and wiring: Building wiring is done in two ways, built-in and surface, depending on the type of project and the application of the building. In surface wiring, the wires are passed through a special electrical pipe or duct to cover the wires through the wall plaster to maintain beauty, order, and security. The advantage of this wiring method is the simplicity in troubleshooting and accessing the wires. Built-in wiring is a very common and applicable method for all types of residential, commercial, office, and other buildings. This method is not only elegant and beautiful due to the invisibility of the wires, but also has more security than the surface wiring method. Built-in wiring is done in two ways.

Virtual training course of building electrical drawing and wiring:

• Basics of electricity
• Electrical circuits
• Technical specifications of building electricity
• Technical lighting and electrical drawing of the building
• Electrical drawing of the building
• Wiring workshop 1
• Wiring workshop 2
• Pipework and wire and cable connections

Types of building electrical maps
1- Real map

It is a map that shows how to connect and install electrical components.

2- Flow path map

It is a map that shows the flow path of the consumer. This map is mostly used to describe the connections and troubleshoot the circuit.

3- Technical and single line map

The technical map shows the assembly method and type of equipment used in the circuit using acronyms and is mostly used for assembly and cost estimation.

4- Command map

It is a map that describes how to control the circuit and, as its name implies, the power command is designed through this map.

5- Electric power circuit diagram

The part of the real circuit that receives energy from the grid and transmits it to the consumer and passes the current consumed by the motor is called the power circuit.

6- Assembly plan

It is used to install parts on the electrical panel, which shows how the equipment is located on the panel.

7- External map

Shows how the parts of an electrical panel and the equipment outside the panel are connected. This map is used to separate the internal and external equipment as well as troubleshoot the parts.

8- Terminal map

Terminal maps can be used instead of external maps and assembly maps. In this map, only the terminals of the control panel along with the input and output wires are drawn.

Prerequisites for building electrical drawing and wiring training course:

• This course does not require special prerequisites and is taught from the ground up.